CVE-2026-23343 PUBLISHED

xdp: produce a warning when calculated tailroom is negative

Assigner: Linux
Reserved: 13.01.2026 Published: 25.03.2026 Updated: 25.03.2026

In the Linux kernel, the following vulnerability has been resolved:

xdp: produce a warning when calculated tailroom is negative

Many ethernet drivers report xdp Rx queue frag size as being the same as DMA write size. However, the only user of this field, namely bpf_xdp_frags_increase_tail(), clearly expects a truesize.

Such difference leads to unspecific memory corruption issues under certain circumstances, e.g. in ixgbevf maximum DMA write size is 3 KB, so when running xskxceiver's XDP_ADJUST_TAIL_GROW_MULTI_BUFF, 6K packet fully uses all DMA-writable space in 2 buffers. This would be fine, if only rxq->frag_size was properly set to 4K, but value of 3K results in a negative tailroom, because there is a non-zero page offset.

We are supposed to return -EINVAL and be done with it in such case, but due to tailroom being stored as an unsigned int, it is reported to be somewhere near UINT_MAX, resulting in a tail being grown, even if the requested offset is too much (it is around 2K in the abovementioned test). This later leads to all kinds of unspecific calltraces.

[ 7340.337579] xskxceiver[1440]: segfault at 1da718 ip 00007f4161aeac9d sp 00007f41615a6a00 error 6 [ 7340.338040] xskxceiver[1441]: segfault at 7f410000000b ip 00000000004042b5 sp 00007f415bffecf0 error 4 [ 7340.338179] in libc.so.6[61c9d,7f4161aaf000+160000] [ 7340.339230] in xskxceiver[42b5,400000+69000] [ 7340.340300] likely on CPU 6 (core 0, socket 6) [ 7340.340302] Code: ff ff 01 e9 f4 fe ff ff 0f 1f 44 00 00 4c 39 f0 74 73 31 c0 ba 01 00 00 00 f0 0f b1 17 0f 85 ba 00 00 00 49 8b 87 88 00 00 00 <4c> 89 70 08 eb cc 0f 1f 44 00 00 48 8d bd f0 fe ff ff 89 85 ec fe [ 7340.340888] likely on CPU 3 (core 0, socket 3) [ 7340.345088] Code: 00 00 00 ba 00 00 00 00 be 00 00 00 00 89 c7 e8 31 ca ff ff 89 45 ec 8b 45 ec 85 c0 78 07 b8 00 00 00 00 eb 46 e8 0b c8 ff ff <8b> 00 83 f8 69 74 24 e8 ff c7 ff ff 8b 00 83 f8 0b 74 18 e8 f3 c7 [ 7340.404334] Oops: general protection fault, probably for non-canonical address 0x6d255010bdffc: 0000 [#1] SMP NOPTI [ 7340.405972] CPU: 7 UID: 0 PID: 1439 Comm: xskxceiver Not tainted 6.19.0-rc1+ #21 PREEMPT(lazy) [ 7340.408006] Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.17.0-5.fc42 04/01/2014 [ 7340.409716] RIP: 0010:lookup_swap_cgroup_id+0x44/0x80 [ 7340.410455] Code: 83 f8 1c 73 39 48 ba ff ff ff ff ff ff ff 03 48 8b 04 c5 20 55 fa bd 48 21 d1 48 89 ca 83 e1 01 48 d1 ea c1 e1 04 48 8d 04 90 <8b> 00 48 83 c4 10 d3 e8 c3 cc cc cc cc 31 c0 e9 98 b7 dd 00 48 89 [ 7340.412787] RSP: 0018:ffffcc5c04f7f6d0 EFLAGS: 00010202 [ 7340.413494] RAX: 0006d255010bdffc RBX: ffff891f477895a8 RCX: 0000000000000010 [ 7340.414431] RDX: 0001c17e3fffffff RSI: 00fa070000000000 RDI: 000382fc7fffffff [ 7340.415354] RBP: 00fa070000000000 R08: ffffcc5c04f7f8f8 R09: ffffcc5c04f7f7d0 [ 7340.416283] R10: ffff891f4c1a7000 R11: ffffcc5c04f7f9c8 R12: ffffcc5c04f7f7d0 [ 7340.417218] R13: 03ffffffffffffff R14: 00fa06fffffffe00 R15: ffff891f47789500 [ 7340.418229] FS: 0000000000000000(0000) GS:ffff891ffdfaa000(0000) knlGS:0000000000000000 [ 7340.419489] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 [ 7340.420286] CR2: 00007f415bfffd58 CR3: 0000000103f03002 CR4: 0000000000772ef0 [ 7340.421237] PKRU: 55555554 [ 7340.421623] Call Trace: [ 7340.421987] <TASK> [ 7340.422309] ? softleaf_from_pte+0x77/0xa0 [ 7340.422855] swap_pte_batch+0xa7/0x290 [ 7340.423363] zap_nonpresent_ptes.constprop.0.isra.0+0xd1/0x270 [ 7340.424102] zap_pte_range+0x281/0x580 [ 7340.424607] zap_pmd_range.isra.0+0xc9/0x240 [ 7340.425177] unmap_page_range+0x24d/0x420 [ 7340.425714] unmap_vmas+0xa1/0x180 [ 7340.426185] exit_mmap+0xe1/0x3b0 [ 7340.426644] __mmput+0x41/0x150 [ 7340.427098] exit_mm+0xb1/0x110 [ 7340.427539] do_exit+0x1b2/0x460 [ 7340.427992] do_group_exit+0x2d/0xc0 [ 7340.428477] get_signal+0x79d/0x7e0 [ 7340.428957] arch_do_signal_or_restart+0x34/0x100 [ 7340.429571] exit_to_user_mode_loop+0x8e/0x4c0 [ 7340.430159] do_syscall_64+0x188/ ---truncated---

Product Status

Vendor Linux
Product Linux
Versions Default: unaffected
  • affected from bf25146a5595269810b1f47d048f114c5ff9f544 to 01379540452a02bbc52f639d45dd365cd3624efb (excl.)
  • affected from bf25146a5595269810b1f47d048f114c5ff9f544 to a0fb59f527d03c60b2cd547cfae4a842ad84670f (excl.)
  • affected from bf25146a5595269810b1f47d048f114c5ff9f544 to c7c790a07697148c41e2d03eb28efe132adda749 (excl.)
  • affected from bf25146a5595269810b1f47d048f114c5ff9f544 to 98cd8b4d0b836d3edf70161f40efd9cbb8c8f252 (excl.)
  • affected from bf25146a5595269810b1f47d048f114c5ff9f544 to 94b9da7e9f958cb3d115b21eff824ecd8c3217aa (excl.)
  • affected from bf25146a5595269810b1f47d048f114c5ff9f544 to 8821e857759be9db3cde337ad328b71fe5c8a55f (excl.)
Vendor Linux
Product Linux
Versions Default: affected
  • Version 5.18 is affected
  • unaffected from 0 to 5.18 (excl.)
  • unaffected from 6.1.167 to 6.1.* (incl.)
  • unaffected from 6.6.130 to 6.6.* (incl.)
  • unaffected from 6.12.77 to 6.12.* (incl.)
  • unaffected from 6.18.17 to 6.18.* (incl.)
  • unaffected from 6.19.7 to 6.19.* (incl.)
  • unaffected from 7.0-rc3 to * (incl.)

References